2024 | eWillys | Page 3 (2024)

Cranks, but doesn’t start. Unclear why the seller thinks this is a military jeep.

https://www.facebook.com/marketplace/item/1168658871246927

“I have a 1963 CJ-6 it’s military issue It has a 3 speed manual and 4 cylinder f134 motor Pros It’s had work done on it new brakes new lines new fuel filter and carburetor new distributor and new starter etc I have photos of proof from the shop that had it done Cons It currently doesn’t start it cranks but doesn’t start it has the stock no seatbelts or airbags feature also no headlights It’s a project car that could be worth a lot when someone puts the work in it I’m still working on it and price will go up if I’m able to get it running good 6500$ firm”

Looks like there is some pars value here.

https://www.facebook.com/marketplace/item/1381361625897573/

“1947 Willy’s jeep cj2a. I bought this already disassembled to restore but my new knees are not going to let me do the work for awhile. original 4-cylinder flat head, 2b windshield, usual rust in floor, couple of dents, but still very restorable. engine turns over with attached 12volt starter.it will be for sale complete until June first, then I will be taking offers on individual parts. message me any questions you may have. Paris Tennessee area. $1600 price is firm as I am taking a loss alread”

UPDATE: Price dropped to $3800.

(06/27/2023) Mark shared this 2A with IHbranded Warn hubs and a custom windshield. This lacks a title.

https://www.facebook.com/marketplace/item/734044378918250

“1947,48 Willy’s Cj2a , runs and drives new tires , IH hubs , good project jeep no title .”

UPDATE: Still Available.

(03/30/2024) There might be some value here given the rear duallies. (this was also listed back in August 2023)

https://www.facebook.com/marketplace/item/423609423678463

“If it’s listed it’s still available No title Not running Bring a trailer Will not part out”

Raymond is selling these never-used fenders. Text 937 789 7021 for more information.

“Pair of rear metal fenders for a Willys pick up truck. Light surface rust, great condition, no dents, see photos. $1,300 for the pair.My Grandpa bought them for his 1963 Willys pickup and never used them— they stayed in his barn after he traded the truck in.
Prefer pick up, cash only. Dayton, Ohio area.”

This has a fiberglass tub. Unclear if that’s really the seller’s price.

https://www.facebook.com/marketplace/item/1005798797795289

“1947 willys Cj2a Fiberglass Tub with title. Original 134 Flathead engine Testing water, looking for real collector. Perfect for family Hobbie.”

UPDATE: Price dropped to $1200.

(04/27/2024) There might be value here.

https://www.facebook.com/marketplace/item/935395731524204

“Clear title. I have the hood, fenders and tailgate. The hood is the only part not pictured that is rust free. The engine in it is locked. I do have a second F-head engine that will be included that had been removed from a running 1960 model (I believe), extra front axle, and lots of extra odds and ends”

UPDATE:Still Available. Now on FB Marketplace.

Looks like a good price for these hard to find parts.

https://www.facebook.com/groups/227689400988963

“Original cast iron 2wd front axle out of a 60s willys DJ3a delivery jeep
Perfect for a sand jeep,gasser or rat rod build
Pahrump 89048
Local pickup only”

I won this rare brochure off of eBay last week. I’ve never seen another one. Wagons, DJ-3As and FCs dominate the photos.

This is the front page. It is 8.75″ wideby 6.5″tall:

The back page is blank:

It opens vertically to this size:

Then opens horizontally to this:

And this view is fully opened at 17.5″ wide by 23.5″ tall:

This is the back fully opened:

TJ shared this potential deal.

https://www.facebook.com/marketplace/item/410412205226362/

“Daily driver. Has a six cylinder engine. Good tires. It’s been a fun project vehicle. Running condition. Being sold as is. Cash only no trades. I will consider reasonable offers.”

This is worth a look. It includes a Koenig hardtop and a PTO winch. It has a few updates, including a heavy duty rear bumper and a steering wheel that I don’t recognize.

https://www.facebook.com/marketplace/item/984664716551028

“1955 CJ 5 Runs and has a clean title Has a new carburetor, fuel pump, and battery. Has a PTO winch $4000 firm”

This has a rare Porter & Reed half cab. The interior looks surprisingly good.

https://www.facebook.com/marketplace/item/1016796679411745

“Will need love does not run brand new tires. Used to be my dad hunting jeep again does not run will need work. Possibly rebuild the motor. 6500 or best offer shoot me ur offer and il talk to my pops about it thank u short video of its first wash in well over 20 years back from when I pulled her out of my backyard”

Lots of potential here. It also includes theKelly top with vertical rear doors. It does have a title issue though.

https://www.facebook.com/marketplace/item/1831665023939412

“very solid Kaiser built CJ-5 restoration project, V-6 Dauntless (Buick) engine in running condition, working snowplow, excellent tires, transmission and clutch in working order, new fuel pump and filter, I flushed the fuel tank and lines which are very clean and rust free, recent oil change, other than surface rust there is no rust rot on the vehicle, floor is solid,

it runs and drives, doesn’t smoke, there is a title but it was signed in the wrong places by the previous owner and DMV wants a new title which requires submitting the existing title and a certified vin verification but CSP will not issue a vin verification unless the vehicle is roadworthy meaning all the lights, horn and wipers work, or you could just bond for a new title…

it also needs a battery, the emission air pump is seized and disconnected, the manual choke cable is stuck and needs replaced or lubed, drivers door latch needs a little work, there are some seeping seals and gaskets but the drivetrain seems in solid condition, some play in the steering, brakes work but could use attention, it was purchased new in Steamboat Springs, lifelong Colorado vehicle and sat in a field for a few years when the fuel pump went out, the odometer reads 05336, so I assume it’s rolled over, a great candidate for restoring though it wouldn’t take much to get it basic working condition and plow your drive. Email questions and contact info”

There’s still some work to be done, but this seems to have potential. Thanks to Andy for sharing it.

https://www.facebook.com/marketplace/item/2091699681186036

“`55 Willys pickup. body and interior mostly finished, Hurricane 226 engine run well but now after sitting a year a couple of valves stuck (remove subject cyl plug and gently tap down as it is turned over). Working plow frame and hydraulics. new gear reduction starter with maybe loose connections or just bad starter.New fuel tank. Decent tires. Bed deck needs replacing, have done nothing to frame and running gear or brakes due to heart problems. new windshields, new seats, lots of rotted body metal replaced. has to be finished but should not take a lot of either time or money. Have more time and money in it than asking price…be nice.”

This may have some Cutlas Bulldog hubs.

https://www.facebook.com/marketplace/item/7053593191413494/

“1953 Willy’s runs but has engine noise. $5,000 OBO”

Note that the driver’s side drain hole is filled.

https://www.facebook.com/marketplace/item/804338271057843

“1948 Willy’s jeep. All body parts are straight and I also have the windshield frame.”

UPDATE: The newowner has installed some new wiring, but it has not been completed.

(10/31/2021) This unusual build has dropped in price to $8999.

https://www.facebook.com/marketplace/item/229330496937146

“1947 Willys Jeep CJ2A. Has half cab installed with seat belts. Early model dauntless v6 engine that runs good, stock 1947 transmission/transfer case/axles. Has PTO and PTO driven winch on front. I got rid of the old wiring and have a 12 circuit harness that I started to install that has a new headlight swtch, turn signal switch, new wiper switch, and a new ignition switch. The lights are 12 volt. I also have a relay panel and switch panel for it. The wiring is routed, but not completed. Due to double knee replacements, I am unable to crawl around the Jeep like I used to. This is a really solid Willys Jeep that would make a great hunting rig or trail rider. I did drive it on the street but 30mph is as fast as these jeeps will go. I am asking $5000 or trade for square body suburban 4×4. ”

These are some older pics.

UPDATE:Price dropped to $5200

(04/15/2024)The seller had been selling two jeeps, not it’s only one.

https://www.facebook.com/marketplace/item/439454708536070

“53 CJ3B does run and stops needs battery but will start with jump start. Asking $5200 Need gone due to health reasons. Have title in hand. ”

Not a whole lot of value here.

https://www.facebook.com/marketplace/item/411064035083327

“No motor no trans no title got it in a package deal someone started making a 2wd rat out of it”

Unclear how much value is here.

“1950 CJ3A for sale. It is located in Raton NM. The Jeep originally was a ranch jeep around Westcliff Colorado before I purchased it.

https://www.facebook.com/marketplace/item/279575891811366

The good:
-Clean title
-All info plates present
-New tires on original 15″ rims
-New valves, valve guides, and lapped seats
-Cylinders honed and rings replaced
-Comes with a complete new brake kit from Walck’s (not installed)
-Very little rust. A couple of little pinholes under the gas tank and one dime sized hole in the front right fender.
-New tires

The “needs attention”:

-The body is pretty banged up from years of being a working Jeep. My intention was to get it going and embrace the character.
-Gas tank is an older aftermarket and it doesn’t fit very well.
-Missing passenger seat and air filter
-Has a late 40’s L134 with a CJ2A engine mount plate. Comes with the correct CJ3A plate, which will need to be installed. The previous owner made an adapter to mount the engine, but the better solution is the put the correct plate on.

This is a neat old ranch Jeep. It probably isn’t a candidate for a fine restoration, but it would make for a really fun farm or hunting truck. It is a project. The engine runs well, but all other systems will need to be gone through.”

Eric’s got this project for sale.

“Title in hand for 1961 Dodge truck.
M201, or V41, without the tool box body.
The M37 bed is from Werner’s in Tracy City, TN.
Located in Kooskia, ID. $2,500.
Text: 540.230.9932
Email: brecciahill @ gmail.com (remove spaces from around the @)”

Still needs some work.

https://www.facebook.com/marketplace/item/795562945866094

“1946 Willy’s CJ2A This has been project jeep run and drives, I installed and new electric distributed, plugs, steering, new lugs, big daddy seat pad, and covers, also the back seat. Witch is rear. Needs more brake work, drivers side glass is broken. Great jeep for someone looking to to hope around town.”

Non running project.

https://www.facebook.com/marketplace/item/1487275722166628

“Clean title 1947 williys jeep with a 302. 302 looks fresh, but non running as it needs a few things. Good body is relatively rust free except one cab corner and a few small holes. Drive train looks to be intact and connect. It’s a project I have and I’ll get to in time just figured I’d put it up for trade to see if someone wants it more. Looking for older fords or toyotas, 4×4 manual preferred, 87 crown vic, older ford wagon, small ford rollback pre 90s or earlier”

Two picsand no info.

https://www.facebook.com/marketplace/item/1544021096164464

UPDATE: Still Available.

(02/29/2024) Unclear how much value is here.

https://www.facebook.com/marketplace/item/3475862329341151

“1947 CJ2A willys tub, frame, axles and other usable parts. What you see on jeep is what is included. ID tag is still attached to frame and readable. Asking $500obo”